WE program 2003-2007 Classic GM truck/SUV Body CONTROL MODULES, OFF THE VEHICLE, FOR PLUG AND PLAY OPERATION. Installation instructions can be found near the bottom of this page.
COST FOR REPROGRAMMED, CUSTOMER SUPPLIED MODULE: $110 (includes return shipping)
FOR PROGRAMMING SERVICE: Please call US AT 314-43FLASH TO ORDER PROGRAMMING FOR THIS SPECIFIC MODULE. AT THE TIME OF ORDER, PLEASE NOTIFY US if the vehicle is equipped with remote keyless entry, as this is specific to the programming process.
IF OLD MODULE IS PROVIDED, WE CAN CLONE PASSLOCK DATA FOR A COMPLETE PLUG AND PLAY INSTALL AT NO ADDITIONAL CHARGE.
ALL MODULES ARE PROGRAMMED TO THE VEHICLE IDENTIFICATION NUMBER (VIN) THAT YOU PROVIDE US. THE VIN IS LOCATED ON THE DRIVER’S DOOR IDENTIFICATION LABEL AND ALSO ON THE LOWER, BOTTOM HALF OF THE DASH ON THE DRIVER’S SIDE.
AT THE TIME OF PURCHASE PLEASE INCLUDE:
-VIN
-YEAR
-MAKE
-MODEL
-PART NUMBER
ORDERS WITHOUT CORRECT INFORMATION WILL BE REFUNDED, IF CONTACT WITH THE BUYER CAN NOT BE MADE. PLEASE CONTACT US WITH ANY QUESTIONS, PRIOR TO PURCHASE.

INSTALLING THE REPLACEMENT BCM IN THE 2003-2006-2007 CLASSIC TRUCK/SUV IS VERY STRAIGHTFORWARD AND IS OUTLINED BELOW.
IF YOU HAVE ACCESS TO THE TECH TERMINAL:
1. LOG INTO THE GM SPS TERMINAL AND PERFORM THE 10 MINUTE VTD RELEARN.
2. AT THE TERMINAL WINDOW, SELECT “REPLACE” THEN NEXT FOR THE VTD RELEARN SELECTION.
IF YOU DO NOT HAVE ACCESS TO THE TECH TERMINAL, A 30 MINUTE RELEARN PROCEDURE MUST BE PERFORMED BY FOLLOWING THESE STEPS:
  1. PLACE A JUMP PACK ON THE VEHICLE. DO NOT LET THE BATTERY DROP BELOW 11.5 VOLTS.
  2. TRY AND START THE VEHICLE.
  3. RETURN THE KEY TO THE RUN POSITION.
  4. WAIT 10 MINUTES. (10)
  5. TURN THE KEY FROM RUN TO OFF.
  6. RETURN THE KEY BACK TO THE RUN POSITION.
  7. WAIT 10 MINUTES. (20)
  8. TURN THE KEY FROM RUN TO OFF.
  9. RETURN THE KEY BACK TO THE RUN POSITION.
  10. WAIT 10 MINUTES. (30)
  11. AFTER THE FINAL 10 MINUTES, RETURN THE KEY TO THE OFF POSITION. THE NEXT CYCLE OF THE KEY WILL NOW RE-LEARN THE PASSLOCK DATA INTO THE REPLACEMENT MODULE.PERSONALIZATION SETTINGS IN THE DRIVER INFORMATION CENTER MAY NEED TO BE RESET. PLEASE CONSULT YOUR OWNER'S MANUAL FOR VEHICLE PERSONALIZATION.
THIS IS A PROGRAMMING SERVICE ONLY. YOU, THE CUSTOMER, MUST SUPPLY A COMPATIBLE POWERTRAIN CONTROL MODULE TO BE PROGRAMMED. PLEASE INCLUDE ALL CUSTOMER CONTACT INFORMATION WHEN SHIPPING THE MODULE. PCM WILL BE FLASHED TO CORRECT YEAR OS (OPERATING SYSTEM) AND HAVE THE PROVIDED VIN PROGRAMMED INTO THE COMPUTER.

BCM Programming Price Change effective 4/9/2018